AGMPL Material Testing Machines
catalogue.
Get your copy TODAY !!!
CLICK.
|
Material Testing Machines
For Testing of
Textiles, Rubber Components, Composites etc.
|
Material
Testing Machine ATTM-2xxx-M |
datasheet |
|
 ATTM-2xxx-M are
microprocessor controlled motorized test stands designed to
automate, simplify and standardize the testing tensile
strength and elongation of different types of materials such
as textiles fabric, rubber, webbing, tape, rope, leather,
plastics etc.
They are fitted with motorized lead screws for cross head
travel. Electronics Load Transducer is used measure the
Force and Displacement Transducer to measure elongation
during testing. Position of the load bar is measured through
a cable potentiometer fitted in the test stand.
Force, on the sample under test, can be applied using front
control panel mounted push buttons or through the
microprocessor based controller. When linked to a PC through
Rs232 (serial) port, these controllers and the specially
designed application software, convert the machine into a
computerized tensile testing facility. Operator can then
view the material characteristics on the VDU (monitor) and
generate test reports through ink-jet printer. Facility also
exists to display a reference or master curve in different
color on the monitor to allow instant assessment of the
quality of the device being tested.
AGMPL also manufactures testing machines for
coil springs and
torsion springs |
|
Specifications |
|
Model |
ATTM 2010M |
ATTM 2050M |
ATTM 2100M |
ATTM 2200M |
|
Force
capacity (KN) |
1 |
5 |
10 |
20 |
|
Cross
head travel |
1200mm |
|
Measuring Resolution
(KN) |
0.001 |
0.001 |
0.01 |
0.01 |
|
Displacement
Resolution |
0.01mm |
Common Specification |
|
Test Speed |
50 to 100 mm / min |
|
Grip Separation |
25 to 1000 mm ; Facility to set
desired grip separation through controller |
|
Travel Limit |
Adjustable through limit switches,
over entire travel range |
|
Transducers Included |
- Load Cell for Force
- Cable potentiometer for cross
head position
- Shaft encoder ( Proximity
switch type) for elongation measurement during test
|
|
Controller Type |
Microprocessor based with 16 char
x 2 line , Backlit, Alphanumeric, Dot Matrix LCD Display and
Membrane Keypad |
|
Modes of Operation |
- Stand alone mode, through
controller
- As computerized test station -
through controller, PC and Software
|
|
Computerized Operation |
Requires connection of the
controller to a PC through Rs232 (COM) Port and application
Software mTest |
|
Test Report Printing |
- Stand Alone Mode- Through
separate dot matrix printer.
- Computerized Mode- Through
separate inkjet or laser printer
|
|
Test Priority |
Force or elongation, User Selectable |
|
Result Parameters |
Force at break , elongation at
break, force vs. elongation chart at predefined steps of force
or elongation depending upon test priority. |
|
Dimensions |
Base- 705 x 525 mm; Overall
Height - 2500mm |
|
Power Source |
230 V AC ± 10 % , 50 Hz |
|
|